First, the principle of clamped stainless steel pipe fittings
1. Principle of pull-out resistance: The middle position of the compression-type pipe fitting is small, but the two ends are large, and the pull-out resistance is >3.0mpa;
2. Leak-stopping principle: An O-shaped sealing ring is installed in the U-shaped groove and shrinks radially tightly to stop leakage, rather than plugging the water;
3. Anti-rotation principle: Special clamping tools clamp it into a hexagonal shape to prevent rotation and leakage during use.
Second, the advantages of stainless steel compression pipe fittings
1. The connection is reliable and safe;
2. Construction is convenient and fast;
3. Suitable for embedded installation;
4. Maintenance-free and update-free, with superior economic performance.
Third, the characteristics of stainless steel compression pipe fittings
1. The construction of pipe fittings is fast and convenient, and the installation time is only 1/3 of the installation time of traditional pipe fittings (a single electric clamping only takes 5 seconds);
2. Pipe fittings are hygienic, environmentally friendly, reliable, economical, long-life, maintenance-free, and update-free.
Fourth, construction precautions for stainless steel compression pipe fittings
1. Stainless steel clamping pipe fittings are all thin-walled stainless steel pipe fittings. Please avoid rough operation to avoid defects and dents. In particular, be careful not to trample on the pipe fittings on site.
2. When storing pipes, try to avoid direct sunlight. Please cover them with plastic tape or security sheets for protection.
3. When the stainless steel compression pipe fittings are stained with oil, be sure to wipe them clean. Especially the pipe ends and rubber sealing rings of pipe fittings, determine whether there are foreign objects. If there are foreign objects, deal with them immediately to avoid more serious consequences.
4. If the pipe fitting cannot be inserted smoothly into the pipe, check whether the burrs on the pipe port have been removed, especially the burrs on the inner wall. The burrs will directly affect the joint between the pipe fitting and the pipe.
5. After the stainless steel clamping pipe fittings are inserted, they should not be clamped temporarily. The threads should be tightened first and then clamped to avoid loosening the clamped joints due to turning the threads.
6. If the piping is bent incorrectly, please correct it on the straight pipe. Do not correct the pipe fittings, as the pinched parts may become loose, which may also cause leakage. Please note.
7. If there is slack in the clamping area, clamp it again at the original clamping area (pay attention to aligning the hexagonal direction).
8. When the piping system is used for media other than water (such as oil, chemicals, gas, etc.), please contact the manufacturer for discussion. The rubber sealing ring may be corroded by the medium and expand and be damaged, causing leakage.
9. Anti-corrosion measures must be taken into consideration when the pipeline system is used near the coast or in places with a lot of salt water. In addition, be very careful when using it in well water, seawater, hot spring water, and fluids with high salt content.
10. When supplying hot water, if the water source is untreated well water, you must consider whether it will have any adverse effects on the piping, so please pay full attention.
Post time: Oct-10-2023